Commands
Sending Commands to a Device
The Command Tab in the Vehicle Management Panel is used to send commands to your tracking devices.
To send a command to a device:
- Select the Vehicle in the Vehicle list to activate the Command Tab for that vehicle
- Open the Command Tab (shown below)
- Select the appropriate command from the list
- Click on “Execute”
As an application Administrator you can control which commands are available (read more about Template Commands below).
The following commands are available in a default installation for most devices:
| Device setup | Sends default setting to the device |
| Poll position | Sends a request to the device for a single position update |
| Start tracking | Starts tracking with the selected tracking method with the current Update interval. The Update interval can be changed in the Track Recorder settings |
| Stop tracking | Stops tracking |
Template commands
You can add additional commands to your application using the Template Command functionality in the Site Admin application.